U.S. Non-Federal-Government Allocations
FIXED
Radiolocation
FCC rule parts
SpectrumWiki
Radio spectrum allocations
Look up a frequency or a range.
Examples: 88.5 MHz, 1350–1430 MHz, 2.4 GHz
89.999 kHz (89,999 Hz)
U.S. Federal Government Allocations
FIXED
MARITIME MOBILE 5.57
Radiolocation
ITU Region 1 Allocations
FIXED
MARITIME MOBILE 5.57
RADIONAVIGATION
ITU Region 2 Allocations
FIXED
MARITIME MOBILE 5.57
MARITIME RADIONAVIGATION 5.60
Radiolocation
ITU Region 3 Allocations
FIXED
MARITIME MOBILE 5.57
RADIONAVIGATION 5.60
Footnotes
-
5.56 The stations of services to which the bands 14-19.95 kHz and 20.05-70 kHz and in Region 1 also the bands 72-84 kHz and 86-90 kHz are allocated may transmit standard frequency and time signals. Such stations shall be afforded protection from harmful interference. In Armenia, Azerbaijan, Belarus, the Russian Federation, Georgia, Kazakhstan, Kyrgyzstan, Tajikistan and Turkmenistan, the frequencies 25 kHz and 50 kHz will be used for this purpose under the same conditions. (WRC 12)
-
5.57 The use of the bands 14-19.95 kHz, 20.05-70 kHz and 70-90 kHz (72-84 kHz and 86 90 kHz in Region 1) by the maritime mobile service is limited to coast radiotelegraph stations (A1A and F1B only). Exceptionally, the use of class J2B or J7B emissions is authorized subject to the necessary bandwidth not exceeding that normally used for class A1A or F1B emissions in the band concerned.
-
5.60 In the bands 70-90 kHz (70-86 kHz in Region 1) and 110-130 kHz (112-130 kHz in Region 1), pulsed radionavigation systems may be used on condition that they do not cause harmful interference to other services to which these bands are allocated.
-
5.61 In Region 2, the establishment and operation of stations in the maritime radionavigation service in the bands 70-90 kHz and 110-130 kHz shall be subject to agreement obtained under No. 9.21 with administrations whose services, operating in accordance with the Table, may be affected. However, stations of the fixed, maritime mobile and radiolocation services shall not cause harmful interference to stations in the maritime radionavigation service established under such agreements.
-
US2 In the band 9-490 kHz, electric utilities operate Power Line Carrier (PLC) systems on power transmission lines for communications important to the reliability and security of electric service to the public. These PLC systems operate under the provisions of 47 CFR part 15, or Chapter 8 of the NTIA Manual, on an unprotected and non-interference basis with respect to authorized radio users. Notification of intent to place new or revised radio frequency assignments or PLC frequency uses in the band 9-490 kHz is to be made in accordance with the Rules and Regulations of the FCC and NTIA, and users are urged to minimize potential interference to the extent practicable. This footnote does not provide any allocation status to PLC radio frequency uses.
Wiki entries
Radiofrequency Identification (RFID)
Current Use
9–135 kHz RFID (inductive systems)
An RFID system consists of an interrogator and a transponder, and is used for identification and data capture. RFID systems are used for a very wide range of applications, including:
Highway tolls
Vehicle tracking
Container tracking
Inventory control & theft prevention (often used to prevent shoplifting)
Healthcare (patient & drug tracking)
Passports
ID cards
Building entry
Livestock & pet tracking
and numerous other applications.
RFID tags can be extremely small devices with little or no internal power, which respond to an interrogation by utilizing some of the RF energy imparted by the interrogator; or they can be larger powered units that can be interrogated over larger distances.
The ITU is in the process of attempting to harmonize RFID bands, since RFID systems are used for global commerce. ITU Study Group 1 (Working Party 1B) is drafting a new ITU-R Recommendation on RFID.
ISO/IEC18000 is the principal standard for the RFID air interface.
RFID systems typically operate in ISM and unlicensed bands.
The bands listed below represent the totality of the various bands presently used around the world. The exact bands used in specific countries may vary (and is what the ITU is attempting to harmonize).
Highway tolls
Vehicle tracking
Container tracking
Inventory control & theft prevention (often used to prevent shoplifting)
Healthcare (patient & drug tracking)
Passports
ID cards
Building entry
Livestock & pet tracking
and numerous other applications.
RFID tags can be extremely small devices with little or no internal power, which respond to an interrogation by utilizing some of the RF energy imparted by the interrogator; or they can be larger powered units that can be interrogated over larger distances.
The ITU is in the process of attempting to harmonize RFID bands, since RFID systems are used for global commerce. ITU Study Group 1 (Working Party 1B) is drafting a new ITU-R Recommendation on RFID.
ISO/IEC18000 is the principal standard for the RFID air interface.
RFID systems typically operate in ISM and unlicensed bands.
The bands listed below represent the totality of the various bands presently used around the world. The exact bands used in specific countries may vary (and is what the ITU is attempting to harmonize).